Control Unit
- Brake
- Cable Reel
-
Lifting Magnet
- ALL
- Electro Magnet
- Electro Permanent Magnet
- Magnetic Separator
- Resistor
- Particle Accelerating Magnet
- Super Conducting Magnet
-
Drive & Control System
- ALL
- Control Unit
- ALL
- TSA-002B
- Under Current Detector
- Control Panel
- Noncontact MC
- Motor Brake Unit
- Moter Speed Detector
- New Battery Charger(TDC-9030)
- Battery Charger
- New Brake Controller (TBC-6020A)
- Brake Controller(TCBⅡ)
- New Magnet Control Unit(TDR)
- Magnet Control Unit(FDR)
- wound rotor motor Controller(FDA)
- Inverter
- Battery Status Monitor(TDP-BM)
- Magnet Controller (TDRSC-50)
- Control System
- CMMS
-
Others
- ALL
- Limit Switch
- ALL
- Differential Switch (TL-D)
- Combination Type (TL-TCN)
- O.S. & Pulse Generator (TL-PC)
- Over Speed Switch (TL-C2)
- Digital Over Speed Switch (TL-OP)
- Digital Over Speed Switch (TL-OPT)
- Screw Type (TL-S)
- Weight Type (TL-G2)
- Weight Type (TL-G)
- Lever Type (TL-L6)
- Lever Type (TL-L5)
- Lever Type (TL-LC)
- Lever Type (TL-LB)
- Lever Type (TL-LA)
- Worm Gear Type (TL-WR8N)
- Worm Gear Type (TL-W4)
- Pantagraph
- Controller
- Drive & Control System
- Control Unit
- FEATURE
- TDP-UC Series is under current detector for magnet to detect current from magnet pots of which installed sensor for using feedback voltage at each pot to find various causes of under current and over current during the magnet operation preventing accidents.
Option
Current detection during transportation and unloading using magnet crane
Features
(1) Adjustment parameters can be set and monitored using LCD
(2) Real-time monitoring of current flowing through each port (maximum 8 ports)
(3) Fault signal output during low current detection during adsorption operation
(4) Alarm signal output during over current detection during adsorption operation
(5) Warning signal output during long-time adsorption operation (time setting possible)
(6) Add setting menu so that it is not influenced by port selection switch ON / OFF during adsorption operation
(7) Wide range of C / T settings, convenient to use according to capacity
(8) Alarm signal output type can be set (toggle A, A-B)
(9) Sensing time can be set considering malfunction due to external noise